Abstract
Carbon nitride films (CNx) have been deposited by sputtering a graphite target with nitrogen ions. Films were grown both with and without the presence of an assisting focused N2 ion beam. The sputter beam voltage was varied between 150 and 1500 V and the applied assisting beam voltage from 80 to 500 V. The substrate was held at fixed temperatures between 80 and 673 K. The coatings were characterized with respect to their electrical, optical, and structural properties. The nitrogen content was measured by x-ray photoelectron spectroscopy (XPS) and a maximum nitrogen concentration of 44 at. % was obtained for a nonassisted sample deposited at 140 K. The chemical structure was investigated by XPS and Fourier transform infrared spectroscopy. Reduction of the substrate temperature in conjunction with low sputter beam voltages (<200 V) caused the optical band gap to increase up to 2.2 eV, the sheet conductivity to decrease to less than 10−9 (Ω cm)−1 and the density to be reduced to 1.6 g/cm3. The increasing transparency is accompanied by structural changes indicating a transition from a predominantly sp2 bonded amorphous sp2/sp3 C–N network to a more linear polymerlike structure consisting predominantly of doubly and triply bonded C and N atoms. No evidence for the formation of the β-C3N4 phase was found.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Journal of Vacuum Science & Technology A: Vacuum, Surfaces, and Films
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.