Synthesis, characterization and properties of biocompatible poly(glycerol sebacate) pre‐polymer and gel

Abstract

AbstractPoly(glycerol sebacate) (PGS) is an elastomer with potential biomedical applications but it suffers from problems with irreproducible synthesis and the unacceptable toxicity of very soft PGS elastomers. To establish the reason for these problems, PGS was synthesized using different temperatures and reaction times, and the reaction was monitored by titration of the unreacted carboxylic groups and measurement of the mass loss during synthesis. It was found that evaporation of glycerol was a major cause of irreproducibility of the elastomer synthesis and this was more significant at higher reaction temperatures. The polymer microstructure was analysed using NMR spectroscopy and all twelve acylglyceride 13C‐signals as well as two small extra peaks of the residual glycerol were observed for the pre‐polymer. For the PGS gel, the glyceride moieties were characterized using NMR spectroscopy for the first time. The modulus and ultimate tensile strength of the gel increased with longer cure times and at higher cure temperatures while the elongation to break decreased and this was interpreted in terms of network theory. The cell viability of mouse fibroblasts was better for PGS samples with a higher conversion.© 2012 Society of Chemical Industry