Abstract
Use of organic ligands to partially passivate nanoparticles against sintering yet retain a degree of small molecule accessibility to the metal surface has been a lofty goal in functional materials synthesis, which in principle also enables the design of preferred electronic and steric environments on a nanoparticle surface. Catalysis using gold in particular requires donor ligands that facilitate an electron-rich metal surface and generalizable strategies for dealing with deactivation due to sintering. Here, synthesis and characterization of gold nanoparticles postsynthetically modified with the chelating ligand cone-5,11,17,23,29,35-hexa(tert-butyl)-37,39,41-tris(diphenylphosphinomethoxy)-38,40,42-trimethoxycalix[6]arene (1) is reported. In solution as well as when supported on the surface of TiO2, nanoparticles modified with tripodal calix[6]arene phosphine ligand 1 demonstrate enhanced protection against sintering relative to unmodified, tetraoctylammonium bromide-surfactant-stabilized gold nanoparticles. In between adsorbed calixarene ligands, there is accessible gold surface area in these nanoparticles, and this is measured quantitatively for the first time for a calixarene-modified nanoparticle, using a newly developed fluorescence methodology involving 2-naphthalenethiol as a relevant chemisorption probe molecule. Ligand steric bulk critically influences amount of accessible surface on the metal nanoparticle since the use of a smaller calix[4]arene ligand (MBC) results in a 7-fold lower accessible surface area relative to using 1 under otherwise similar conditions. In addition, surface coverage of 1 controls accessible surface area in an unintuitive fashion: a 4-fold increase in accessible metal surface area is observed upon increasing the surface coverage of 1 to be 1.5-fold higher than the minimum required for surface saturation. This is presumably the result of a more open ligand packing of 1 at higher surface coverages, which allows greater accessibility to 2-napthalenethiol.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have