The impact of mineral reactive surface area variation on simulated mineral reactions and reaction rates

Abstract

Reactive transport modeling is an essential tool to simulate complex geochemical reactions in porous media that can impact formation properties including porosity and permeability. However, simulating these reactions is challenging due to uncertainties in model parameters, particularly mineral surface areas. Imaging has emerged as a powerful means of estimating model parameters including porosity and mineral abundance, accessibility and accessible surface area. However, these parameters, particularly mineral accessible surface area, vary with image resolution. This work aims to enhance understanding of the impact of image resolution and other means of estimating mineral reactive surface area on simulated mineral reactions and reaction rates. Mineral surface areas calculated from images with resolutions of 0.34 μm and 5.71 μm were used to simulate mineral reactions in the context of geologic CO2 sequestration in the Paluxy formation at the continuum scale. Additional simulations were carried out using BET surface areas collected from the literature and geometric surface areas. Simulations were run for 7300 days and mineral volume fractions and effluent ion concentrations tracked and compared. Variations in mineral surface areas measured from images are within 1 order of magnitude and yield similar simulation results, indicating the impact of image resolution on simulated reactions and reaction rates is minimum for the resolutions and sample considered. In comparison, surface areas obtained from BET and geometric approaches are 1–4 orders of magnitude higher than image-obtained surface areas and result in greater simulated reaction rates and extents. Minerals with high reaction rates (calcite and siderite) are most impacted by surface area values at short times where simulated mineral volume fractions at longer times agree relatively well, even for simulations with several orders of magnitude variation in surface area. Phases with lower reaction rates, such as K-feldspar and muscovite, are predominantly impacted over longer times where variations in surface areas impact reaction extents and porosity evolution. Overall, variations in surface areas due to image resolution are small and result in little variation in simulated reactions and reaction rates while there are significant variations in simulation results when other surface area estimates are used. These variations, however, depend on the reactivity of the mineral phase where surface areas of fast-reacting phases largely impact simulations at short (hours to days) timescales and surface areas of slower-reactive phases impact longer term simulations (years).