Abstract
Carboxylic esters were successfully labeled with one of two short-lived positron-emitters, carbon-11 or fluorine-18, within a hydrodynamically-driven micro-reactor. The non-radioactive methyl ester was obtained at room temperature; its yield increased with higher substrate concentration and with reduced infusion rate. Radioactive methyl ester was obtained from the reaction of (10 mM) with in 56% decay-corrected radiochemical yield (RCY) at an infusion rate of 10 microL min(-1), and when the infusion rate was reduced to 1 microL min(-1), the RCY increased to 88%. The synthesis of the non-radioactive fluoroethyl ester from and required heating of the micro-reactor on a heating block at 80 degrees C (14-17% RCY), whilst the corresponding radioactive from and was obtained in 10% RCY. The radioactive 'peripheral' benzodiazepine receptor ligand was obtained from the reaction of acid with labeling agent in 45% RCY at an infusion rate of 10 microL min(-1). When the infusion rate was reduced to 1 microL min(-1), the RCY increased to 65%. The results exemplify a new methodology for producing radiotracers for imaging with positron emission tomography that has many potential advantages, including a requirement for small quantities of substrates, enhanced reaction, rapid reaction optimisation and easy product purification.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.