Abstract

AbstractSummary: Five modes describing the behaviour of cellulose fibres dipped in a chemical have been identified: Mode 1: Fast dissolution by disintegration into fragments Mode 2: Large swelling by ballooning, and dissolution Mode 3: Large swelling by ballooning, and no dissolution Mode 4: Homogeneous swelling, and no dissolution Mode 5: No swelling and no dissolution In the case of the behaviour of wood and cotton cellulose fibres in N‐methylmorpholine‐N‐oxide (NMMO) and water mixtures, four domains of water content have been identified. Below 17% of water up to monohydrate (13%), the fibres are disintegrated into rod‐like fragments and dissolve (mode 1). In NMMO – water mixtures containing 19–24% water, the cellulose fibres exhibit a heterogeneous swelling by forming balloons (composed of dissolved cellulose holds inside a membrane) separated with non‐swollen sections. The whole fibre will completely dissolve (mode 2) in four successive steps (growth of the balloons, burst of the balloons, dissolution of the non‐swollen sections and finally dissolution of the membrane). With still greater water contents (25–30%), only the ballooning phenomenon is observed, with a partial dissolution inside the balloon (mode 3). Above 35% of water, the fibres swell homogeneously and are not dissolving (mode 4).

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.