Abstract
Bioinspired, bistable snap-through structures are promising to release a burst of mechanical energy transformed from chemical energy, stored, and released incrementally during swelling/deswelling. Thin, disk-like hopper can harness the inhomogeneous deswelling to create the required constraint and flexible snap-through part. Here, hoppers composed of a single type of polydimethylsiloxane (PDMS) or concentric PDMS rimmed by a stiffer PDMS are cast into precisely micromachined molds. The mechanical properties and swelling/deswelling behavior of the constraining rim and flexible snap-through materials, in concert, allow a superior specific power of 1782 W kg−1, specific energy of 4.44 J kg−1 for a jump up to 321 mm, outperforming many more complex implementations. The jump benefits from an improved storage modulus ratio and a lower swell of the rim to the snap-through center part, which enhanced the confinement and elastic energy storage. A sharp spatial gradient in volume change between the two materials during deswelling, tunable by the porosity of the rim materials, enhances the jumping by allowing more material to store and release elastic energy, revealed by the strain analysis with 3D-digital image correlation. The illustrated multimaterials and porous materials strategies can promote the development of integrated energy harvesting and actuation for soft robotics.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.