Surface Roughness Evaluation of Blast-Cleaned Structural Steel Plates Considering Measurement Deviation

Abstract

AbstractSurface roughness is an important characteristic of blast-cleaned structural steel plates. This is because the adhesion of the coating and the frictional grip of the bolted connections are related to surface roughness. Surface roughness is usually measured using a surface roughness meter. Because the roughness of blast-cleaned surfaces is not uniform, it varies from position to position. The surface roughness test results obtained from a broad area are more valuable than those obtained from a narrow area. Because the measured values contain deviations, they are measured multiple times and averaged to reduce the influence of deviations. However, to evaluate roughness, it is necessary to clarify the measurement conditions to obtain accurate results. Consider combining these sentences as follows: In this study, the surface roughness of the blast-cleaned structural steel sample was measured at multiple locations to obtain its distribution characteristics. During each sample measurement, the detection sensor of the surface roughness meter was lifted and placed on the steel sample to determine deviations from the actual results. The surface roughness distributions of five blast-cleaned samples were the same under the identical measurement conditions. This indicates that accurate results can be obtained by measuring representative samples, without the need for measuring all samples; actually, 17 measurements were adequate to obtain a mean surface roughness value with a 95% confidence level and a 5% acceptable error rate.