Abstract
Groove shape effect on wear behavior in PTFE radial bearings under rolling contact fatigue (RCF) was investigated. RCF tests in water-lubricated conditions were carried out at different loads and rotation speeds. The groove surfaces after testing were observed by using a laser confocal microscope and a two-dimensional shape measurement sensor. It was found that PTFE bearings under RCF generate wear debris, however no cracking or flaking failure could be observed. It is concluded that groove deformation depend on load rather than rotation speed. The biggest changes in groove profiles occurred when tested at loads close to 400N.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.