Surface potential and mobile charge based drain current modeling of double gate junctionless accumulation mode negative capacitance field effect transistor

Abstract

AbstractAn analytical drain current model for double gate junctionless accumulation mode negative capacitance field effect transistor (DG‐JAM‐NC‐FET) has been developed, combining the merits of junctionless accumulation mode and negative capacitance effect such as fabrication feasibility, low power dissipation, and reduced degradation in mobility. The novelty manifested in our work is because of the incorporation of the JAM structure in ferroelectric‐based negative capacitance FET. The benefit of JAM over existing FETs is that it combines the benefits of the junctionless transistor (JLT) and conventional FETs. It avoids excessive parasitic resistance due to stronger doping in the source and drain areas, resulting in higher conductivity and better characteristics than JLT. An analytical surface potential and threshold voltage have been developed using Poisson's equation and Landau Khalatnikov's (L‐K) equation. The drain current is then determined by integrating the mobile charge using the Pao–Sah integral. Various critical parameters such as surface potential, gain, capacitance, mobile charge density, drain current, threshold voltage, subthreshold swing, transconductance, and the switching ratio have been assessed extensively by varying ferroelectric layer and channel layer thicknesses, respectively. The ON current increases with the increase in ferroelectric thickness due to the voltage amplification given by the ferroelectric layer, and the switching curve gets steeper. The analytical modeling is done in MATLAB, and its comparison is made with the TCAD numerical simulation. The obtained analytical results and the numerical simulation results correspond well.