Surface Hardening of Stainless Steel

Abstract

The addition of nitrogen to stainless steel improves mechanical and corrosion properties. Nitrogen-bearing stainless steel (HNSS) is a new corrosion-resistant alloy class exhibiting better tribological properties. High-pressure and powder metallurgy techniques were developed for the fabrication of HNSS. Solid-state routes allow nitrogen introduction through thermochemical, implantation, or plasma surface treatments. High-temperature gas nitriding (HTGN), carried out in an N2 atmosphere in the 1000°C range, allows N uptake, obtaining thick, ~0.5–1.0 wt.% N austenitic cases. HTGN is different from conventional nitriding, performed in the 500°C range, where intense CrxNy precipitation occurs, impairing the corrosion resistance. Low-temperature plasma nitriding (LTPN) introduces more N in solution, and colossal supersaturated expanded phases (~45 at.%N) are formed. N supersaturation and compressive stresses increase the hardness of the surface layer to 10–14 GPa. Ferritic, martensitic, duplex, and precipitation-hardened stainless steels can be surface-treated by LTPN, obtaining expanded ferrite and martensite. However, single LTPN stainless steel may prematurely fail when submitted to high loading, as the thin and hard expanded layers collapse due to lack of load-bearing capacity. Duplex-nitriding treatment (HTGN + LTPN) results in a thick nitrogen-rich hardened austenite substrate layer, granting mechanical support and adhesion to the expanded austenite layer.