Abstract
AbstractUniform film deposition over an entire substrate is indispensable to achieve efficient perovskite solar modules (PSMs) by minimizing the gap with high‐performance perovskite solar cells (PSCs). Only a few microscopic pinholes on the film in PSMs directly give rise to debase the performance and stimulate the degradation of the devices. Herein, a strategy of the homogeneous and defect‐reduced electron‐transport layer for high‐performance PSMs is reported. pH modulation of tin oxide (SnO2) nanoparticles colloidal dispersion by a small amount of nitric acid (HNO3) addition leads to the removal of hydroxy groups on the SnO2 surface acting as electronic defects as well as superb regularity of the thin films by forming a network of the SnO2 nanoparticles. The surface engineering of SnO2 nanoparticles brings out the high performance of 23.7% efficiency for a unit cell, 20.3% efficiency for a 24.5 cm2 minimodule, and 19.0% efficiency for a 214.7 cm2 submodule, respectively, where all efficiencies are averaged from results obtained by the reverse/forward scan. In outdoor tests with the submodules, a target PSM generates 16.5% higher cumulative electricity for a month as compared to a control PSM. Furthermore, under damp heat environments, the target PSM maintains 80% efficiency compared to an initial efficiency of 1080 h.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call