Surface deformation caused by April 6th 2009 earthquake in L’Aquila (Italy): A comparative analysis from ENVISAT ASAR, ALOS PALSAR and ASTER

Abstract

Surface deformations in L’Aquila (centre of Italy) caused by the April 6th, 2009 earthquake were studied from space geodesy and remote sensing points of view using Synthetic Aperture Radar Interferometry (InSAR) and Sub-pixel Correlation Technique (SCT). InSAR was used to measure ground surface deformation in the satellite line of sight (LOS) direction and the deformation was determined using two separate interferometric pairs of ENVISAT ASAR and ALOS PALSAR data sets. Furthermore, SCT was employed to investigate the horizontal displacements in the area. Two separate pairs of ENVISAT ASAR and ASTER optical image data sets were employed, and horizontal displacements in Range/Azimuth and in west–east/south–north directions were investigated, respectively.Maximum 28.1cm subsidence in LOS direction was observed on the descending interferogram of the ENVISAT ASAR data set, to the north-west of Onna village. The initial coseismic surface deformation started from the north of the main event epicentre. Most of the post-seismic relaxation occurred after April 7th, toward the south and south-east of the main shock epicentre, and results from SCT showed that the horizontal displacement was not significant on the surface (not more than a few centimetres).