Abstract
AbstractIn the course of the development of a new fine‐pitch four‐point probe, surface oxide layers of the probe material were characterized by a non‐destructive depth profiling analysis with a variable excitation XPS using synchrotron radiation. The high surface sensitivity of this technique has allowed us to measure the ultra‐thin thickness of the oxide layer on the probe material without damage. The XPS of W 4f of the tungsten metal was measured in the excitation x‐ray energy range 100–1200 eV at the Photon Factory (BL‐13C), Tsukuba, Japan and analysed by the simulation of attenuation in the layer models using the values of inelastic mean free path (IMFP) and effective attenuation length (EAL) calculated by the National Institute of Standards and Technology (NIST) database programs 71 and 82, respectively. The values of practical EAL at 1 nm depth were smaller than the IMFP by 20–40% and resulted in a smaller thickness of the surface oxide layer than for that of IMFP by about 20%. The result showed that the thickness of the surface oxide layer of the tungsten metal was 1.0 nm ‘as received’ and 0.5 nm after polish. The XPS of W 4f of the superfine grain (grain size < 0.5 µm) tungsten carbide–cobalt wires with 0.45 mm diameter, which is a probe size of conventional four‐point probes, were measured and the results indicated that the thickness of the surface oxide layer of the tungsten carbide–cobalt was 0.4 nm ‘as received’, and the thickness of the oxide layer was increased to 0.5 nm after polish. The XPS of W 4f of the tungsten carbide–cobalt wire with 0.05 mm diameter of an actual probe for a new fine‐pitch four‐point probe system was also measured and the results indicated that the thickness of the surface oxide layer was 0.6 nm. The XPS of W 4f also indicated the existence of an intermediate thin layer of WO2 between W and WO3. Copyright © 2004 John Wiley & Sons, Ltd.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.