Abstract
Catalytic conversion of CO2 to CO via the reverse water gas shift (RWGS) reaction has been identified as a promising approach for CO2 utilization and mitigation of CO2 emissions. Bare Pt shows low activity for the RWGS reaction due to its low oxophilicity, with few research works having concentrated on the inverse metal oxide/Pt catalyst for the RWGS reaction. In this work, MnOx was deposited on the Pt surface over a SiO2 support to prepare the MnOx/Pt inverse catalyst via a co-impregnation method. Addition of 0.5 wt% Mn to 1 wt% Pt/SiO2 improved the intrinsic reaction rate and turnover frequency at 400 °C by two and twelve times, respectively. Characterizations indicate that MnOx partially encapsulates the surface of the Pt particles and the coverage increases with increasing Mn content, which resembles the concept of strong metal–support interaction (SMSI). Although the surface accessible Pt sites are reduced, new MnOx/Pt interfacial perimeter sites are created, which provide both hydrogenation and C-O activation functionalities synergistically due to the close proximity between Pt and MnOx at the interface, and therefore improve the activity. Moreover, the stability is also significantly improved due to the coverage of Pt by MnOx. This work demonstrates a simple method to tune the oxide/metal interfacial sites of inverse Pt-based catalyst for the RWGS reaction.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have