Study on Verification Approach and Multicontact Points Issue When Modeling Cyperus esculentus Seeds Based on DEM

Abstract

In this paper, the Multisphere (MS) models of three varieties of Cyperus esculentus seeds are modeled based on DEM. In addition, for comparison, other particle models based on automatic filing in EDEM software are also introduced. Then, the direct shear test, piling test, bulk density test, and rotating hub test are used to verify the feasibility of particle models of Cyperus esculentus seeds that we proposed. By comparing the simulated results and experimental results, combined with the CPU computation time, the proposed particle models achieved better simulation accuracy with fewer filing spheres. According to simulation results, some limitation was present when using one single verification test; varieties of verification tests used could improve the verification reliability, and a more appropriate particle model could be selected. Additionally, the issue of multicontact points in the MS model was studied. The Hertz Mindlin (no slip) (HM) model and Hertz Mindlin new restitution (HMNR) model were both considered in simulations for comparison. The rotating hub test and particle–wall impact test were used, and the influences of multiple contact points on the motion behavior of individual particles and particle assemblies were analyzed. Simulation results showed that the multiple contact points affected the motion behavior of individual particles; in contrast, the influence of multiple contact points on the motion behavior of the particle assembly was insignificant. Moreover, the relationships between moisture content of seeds and Young’s modulus, Young’s modulus, and the number of contact points were also considered. Young’s modulus decreased with increasing moisture content. The number of contact points increased with a decreasing Young’s modulus.