Study on the performance of sealing slurry at the bottom of geomembrane composite vertical cut off walls

Abstract

At the bottom of the geomembrane cut-off walls, pollutants may seep out through the bottom gap between the geosynthetic membrane and the low-permeability bedrock, contaminating the groundwater and the surrounding environment. Therefore, to address the occurrence of bottom gap seepage, this study adopts a mixture of attapulgite and cement in a certain proportion, mixed and stirred to form a sealing material. This sealing material is used to connect the bedrock and the geosynthetic membrane, thereby creating an efficient composite vertical barrier with special containment capacity. A series of laboratory experiments were conducted to investigate engineering properties of cement-attapulgite sealing slurry, including flow value tests, unconfined compressive strength (UCS) tests, improved flexible wall permeability tests, and bedrock and sealing slurry adhesion tests. The results show that the flow value of the slurry decreases with the increase of attapulgite content, and it increases with the increase of water-cement ratio. The UCS strength increases with the increase of attapulgite content, and it decreases with the increase of water-cement ratio, but the range of change is different. The hydraulic conductivity measured with hexavalent chromium solution as the penetrant is less than 50 % higher than that measured with water as the penetrant, and hexavalent chromium solution has little effect on the hydraulic conductivity of sealing slurry. The bonding performance between sealing slurry and bedrock is satisfactory, and the hydraulic conductivity of bedrock-sealing slurry is less than 1 × 10−7 cm/s (28d curing age), it is concluded that use of cement-attapulgite sealing slurry as bonding material between bedrock and geomembrane meets the engineering design requirements.