Abstract
Plastic foam molding methods include thermoforming, extrusion and injection molding. Injection foam molding is a one-time molding method with high production efficiency and good product quality. It is suitable for foamed plastic products with complex shapes and strict size requirements. It is also the main method for producing structural bubbles. In this investigation, we developed a structural foam injection molding technology using the gas supply equipment connected to the unique plasticizing mechanism of the injection machine and studied its influence on the specimens' melt rheology quality and foam structures. In the experiment, the forming material was polypropylene (PP), and the gas for mixing/forming foaming characteristics was nitrogen (N2). Additionally, in order to observe the rheological properties of N2/melt mixing, a melt flow specimen mold cavity was designed and the change in the melt viscosity index was observed using a melt pressure sensing element installed at the nozzle position. With the nitrogen supply equipment connected to a unique plasticizing mechanism, the mixing of gas and molten plastic can be achieved at the screw plasticizing stage, where the foaming effect is realized during the melt-filling process due to the thermodynamic instability of the gas. It was also found that an increase in N2 fill content increased melt fluidity, and the trend of melt pressure and melt viscosity index showed that the higher the gas content, the lower the trend. The foaming characteristic depends on the gas thermodynamic instability and the pressure release, so it can be seen from the melt fill path that, the greater the pressure near the gate, the lower the foaming amount and the internal structure (SEM) after molding; the farther from the gate, the greater the relative increase in the foaming growth/amount. This phenomenon will be more obvious when the N2 fill content is increased.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have