Study on the correlation between grain size and processing limit in abrasive flow machining

Abstract

The influence of particle size on the abrasive flow machining mechanism and processing limit was studied by establishing the processing model of different particle size. When many scholars studied the mechanism of abrasive flow machining in the past, they only established a machining model and ignored the effect of abrasive particle size. By comparing the size of different granularity abrasive particles and the workpiece surface in contact with each other, the large granularity abrasive particle processing model and the small granularity abrasive particle processing model were put forward, and their processing mechanism was analyzed respectively. On this basis, the reason of machining limit in different particle size abrasive processing process is explained. Finally, the theoretical analysis and experimental results were compared to verify the correctness of the processing mechanism and theoretical analysis of processing limit of abrasive with different granularity, and an optimal experimental scheme was proposed to break through the original processing limit.