Study on forming accuracy of ZrO2 ceramic materials prepared by DLP technology

Abstract

DLP technology is one of the 3D printing methods for ceramic materials, and its forming accuracy is affected by the preparation of ceramic slurry, debinding and sintering process. In view of three different slurry preparation methods and solid content, the flow characteristics of slurry were studied. The reasonable debinding and sintering process was formulated, and the debinding and sintering treatment were carried out. The influence of slurry preparation methods on the forming accuracy of green parts and sintered parts was found out. The results show that with the increase of solid content, the viscosity of slurry also increases and the fluidity becomes worse. Increasing milling time and rotating speed can improve the flow characteristics of the slurry with 70% zirconia solid content. The C method can not only increase the solid content of the slurry, but also reduce the shrinkage of the sintered parts and improve the dimensional accuracy of the sintered parts.