Study of the TIG Welding Process of Thin-Walled Components Made of 17-4 PH Steel in the Aspect of Weld Distortion Distribution.

Abstract

This article presents the results of a study on the distribution of weld distortion in thin-walled components made of 17-4 PH steel, resulting from TIG (Tungsten Inert Gas) welding. Both manual and automatic welding processes were examined. Physical simulation of the automated welding process was conducted on a custom-built welding fixture. Analysis of weld distortion in thin-walled components made of 17-4 PH steel was based on the results of measurements of transverse shrinkage and displacement angle values. These measurements were taken on thin-walled parts before and after the welding process using a coordinate measuring machine (CMM). To determine the effect of manual and automated welding processes on the microstructure of the welded joint area, metallographic tests and hardness measurements were performed. The microstructure was analyzed using a scanning electron microscope (SEM). An analysis of the chemical composition of selected welded joint zones was also conducted. These tests were performed using an optical emission spectrometer (OES). According to the results, the use of automated welding and special fixtures for manufacturing thin-walled aircraft engine components made of 17-4 PH steel reduces the propensity of these components for distortion due to the effects of the thermal cycle of the welding process. This conclusion is supported by the results of the observation of the microstructure and analysis of the chemical composition of the various zones of the welded joint area.