Study of the Influencing Factors on the Small-Quantity Fuel Injection of Piezoelectric Injector.

Abstract

The piezoelectric injection-system provides a reliable approach for precise small-quantity fuel injection due to its fast, dynamic response. Considering the nonlinearity of a piezoelectric actuator, the complete electro-mechanical-hydraulic model of the piezoelectric injector was established and verified experimentally, which showed that it could accurately predict the fuel injection quantity. The small-quantity fuel injection with different driving voltages, pulse widths, and rail pressures was analyzed. The effects of key structural parameters of the injector on the delivery, control-chamber pressure fluctuation, and small-quantity injection characteristics were studied. The results show that the linearity of the curve of the injection volume with the pulse width was relatively poor, and there was a significant inflection point when the piezoelectric injector worked in the small pulse width region (PW < 0.6 ms). The bypass valve significantly accelerated the establishment of the control-chamber pressure, reduced the pressure fluctuation in the chamber, shortened the closing delay and duration of the needle valve, and reduced the rate of the fuel-quantity change so that it provided a greater control margin for the pulse width over the same fuel volume change interval. Under the condition of a small-quantity fuel injection of 20 mm3, decreasing the inlet orifice diameter and increasing the outlet orifice diameter shortened the minimum control pulse width and fuel injection duration required for the injector injection, which is beneficial for multiple and small-quantity fuel injection. However, these behaviors reduce the control margin for the pulse width, especially in small pulse width regions.