Abstract
AbstractThis paper describes a new measuring method for the phase current in a high‐voltage three‐phase cable. Twenty‐four pieces of independent coils wound around the coreless bobbins are used to make a CT sensor. The primary phase current may be calculated based on the output voltage of each coil. The certain correlation between the output voltage and primary phase current is observed by the experimental data. This new CT sensor enables the measurement of the phase current using the whole conductors clamping method for a three‐phase cable. © 2008 Wiley Periodicals, Inc. Electr Eng Jpn, 165(2): 9–20, 2008; Published online in Wiley InterScience (www.interscience.wiley.com). DOI 10.1002/eej.20753
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.