Abstract

AbstractTo study the penetration depth in the case of a gas jet impinging on the surface of liquid steel, cold model experiments were carried out using a liquid alloy Ga–In–Sn, which had similar physical properties as liquid steel. A HCl solution was used to simulate the top slag. The top phase was found to have appreciable effect on the penetration depth. Comparison of the experimental data with the predictions of the existing models indicated that most the model predictions deviated from the experimental results at higher lance heights and gas flow rates. New model parameter was suggested based on the present experimental data. The observation of the formation and movement of metal droplets generated by the gas jet was also made. The velocity of the droplet was found to be at a level only about 1% of the terminal velocity. This low velocity suggested that the turbulent viscosity played important role and the droplets could have long resident time in the slag.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.