Abstract

In the article, the study of laser beam modulation influence on the structure of materials produced by one of the methods of additive manufacturing as selective laser melting (SLM) is provided. For the purpose of creating a smoother temperature gradient and the optimal conditions of the heat and mass transfer in the melting pool, an experimental stand for SLM-processing with the system of laser beam power density distribution modulation was created. The laser beam modulation gives promising results for higher parameters’ combinations such as power more than 150W and scanning velocity more than 50 mm/sec. The single track’s formation was produced by different power density distribution as Gaussian, Flat-top and Inverse Gaussian (Donut). All the received single tracks were studied with the use of optical and SEM microscopy. The results produce important data about reducing the width of powder consolidation zone, more even structure and higher productivity. Copyright © 2016 VBRI Press.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.