Study of injection molding process simulation and mold design of automotive back door panel

Abstract

Numerical simulation of the injection molding process of the outer panel of the automotive plastic rear door and mold design is presented here. Computer aided three-dimensional interactive application (CATIA) is employed to design the original automotive steel structure, and the modal and thermodynamic properties of the plastic back door outer panel are changed by changing the different injection materials of the back door outer panel. In order to efficiently design the panels, finite element analysis is used to verify whether the designed parts meet the mechanical properties requirements such as light weight, low fuel consumption, short production cycle, strong modeling design, high corrosion resistance and good recovery, the above main parameters have been evaluated, and the above main parameters are carried out evaluate. To simulate the injection molding process, computer aided engineering (CAE) software such as ANSYS and HyperWorks are used to analyze the back door of the selected material. After the numerical analysis, suitable material is selected, so that the modal and thermodynamic properties of the product could be satisfied as well as improved. Unigraphics NX (UG) is employed to design the convex and concave mold for the injection molding of the automobile’s plastic back door panel. Combined with the characteristics of the parts and the design requirements of the injection mold, the multi-scheme design of the pouring and cooling system is carried out. By comparing the effects of different gating and cooling systems on injection molding, the best gating and cooling system is selected. The artificial fish swarm algorithm is used to optimize the process parameters of the injection molding process, and the best combination of the injection molding process parameters of the outer panel of the rear door of the automobile is obtained.