Study of Aluminum-doped zinc oxide current spreading layer on P-side up thin-film AlGaInP-based light-emitting diodes by ALD

Abstract

A twice wafer-transfer technique can be used to fabricate high-brightness p-side-up thin-film AlGaInP-based light-emitting diodes (LEDs) with an aluminum-doped zinc oxide (AZO) thin films transparent conductive layer deposited on a GaP window layer. The GaP window layer consist of the two different doping profile, the carbon doped Gap (GaP:C) window layer of 50 nm is on the top of Mg doped GaP window layer of 8 μm. The GaP:C window layer is used to improved the ohmic contact properties of GaP:C/AZO. The AZO with different cycle ratio of Zn:Al (15:1, 20:1 and 25:1) is deposited on GaP:C window layer as current spreading layer by atomic layer deposition. The AZO layer can be used to improve light extraction, which enhances light output power. The output power of p-side-up thin-film AlGaInP LED with an AZO layer of 20:1 cycle ratio has improved up to 19.2 % at injection current of 350 mA, as compared with that of LED without AZO film. The p-side-up thin-film AlGaInP LED with AZO current spreading layer exhibited excellent performance stability, the emission wavelength shift of p-side-up thin-film AlGaInP LED without and with AZO thin film(Zn:Al=20:1) are 17 nm and 3 nm under the injection current increased from 20 mA to 1000mA, respectively. This stability can be attributed to the following factors: 1) Refractive index matching, performed by introducing AZO thin film between the epoxy and the GaP window layer enhances light extraction; and 2) the favorable thermal dissipation of the silicon substrate reduces thermal degradation.