Study and comparison of wear behaviour of Ni-Al2O3 coatings deposited by hot and cold spray

Abstract

The sliding wear of hot and cold spray nickel-alumina coatings on SA 213-T 91 boiler steel has been evaluated and compared. The investigation was conducted with pin-on-disc apparatus. The wear testing was done by varying normal loads of 30, 40, and 50 N at a constant sliding velocity of 1 ms−1. Then another set of experimentation was done at different sliding velocities of 0.5, 1, and 2 ms−1 at a constant normal load of 30 N. This experimentation was designed to study the effect of varying normal loads and sliding velocities on the wear performance of coatings developed with hot and cold spray techniques. The variation of friction coefficient and wear rate with variation in normal loads and sliding velocities were plotted and analyzed. The evaluation of wear mechanisms and characteristics of Ni-Al2O3 coatings is done with the help of weight change measurements and FE-SEM analysis. The wear resistance of hot spray coatings was found better at high normal loads and sliding velocities in comparison to cold sprayed coatings.