Abstract

Determination of potential vitamin D2 (the sum of vitamin D2 and pre-D2) in UV irradiated products of ergosterol was investigated by a GLC method. Both vitamin D2 and pre-D2 were quantitatively isomerized into the thermal cyclized products “pyro- and isopyro-D2” by GLC. It was previously reported that the separation of pyro-D2 from lumisterol2 was difficult (6, 7), but their separation has been found to be successfully achieved by applying the TMS ethers of samples to the GLC using the following apparatus and analytical conditions: apparatus, a Shimadzu GC-4APTF gas chromatograph equipped with a hydrogen flame ionization detector; column, a glass column (0.4×150cm) packed with 1.5% OV-17 on Shimalite W (80-100 mesh); column temperature, 215°; flow rate of nitrogen gas, 80ml/min. Recovery tests of vitamin D2 in the mixtures of vitamin D2 isomers by the GLC gave good results, and no special inhibitory peak was observed in the gas chromatogram of irradiated ergosterol products. From these results, the GLC procedure applicating the operating parameters mentioned above after trimethylsilylation of samples and using the peaks of pyro-D2 TMS ether and stigmasteryl acetate as an internal standard was established as a routine method for the determination of potential vitamin D2 in irradiated ergosterol products.The effects of ergosterol concentrations, temperatures, solvents, use of a filter solution and light sources on the yield of potential vitamin D2 were examined by using this method. The effects of light sources and ergosterol concentrations were large, whereas the other conditions gave little effects.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.