Abstract
AbstractStudies are presented on melt rheological properties of binary blend of polypropylene (PP) and acrylonitrile–butadiene–styrene terpolymer (ABS), and ternary blend of PP, ABS, and low‐den‐sity polyethylene (LDPE). Data obtained in capillary rheometer are presented to describe the effect of blending ratio, shear stress, and shear rate on flow properties, melt viscosity, and melt elasticity. At a blend composition corresponding to 10 wt % ABS content, both binary and ternary blends show maximum in melt viscosity accompanied by minimum in melt elasticity. Pseudoplasticity of the melt decreases with increasing ABS content. In ternary blends, LDPE facilitates the flow at low LDPE contents and obstructs the flow at high LDPE contents. Scanning electron microscopic studies are also presented to illustrate the state of dispersion and its variation with blend composition.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.