Abstract
A liquid crystalline polymer (LCP) was synthesized by an interfacial polycondensation reaction at room temperature from terephthaloyl chloride and p,p′-dihydroxydiphenyl sulfone. The LCP synthesized was so stable and molecularly rigid that it did not show any phase transition until it degraded at about 320°C. Composites of the LCP with polycarbonate (PC), polystyrene (PS), and sulfonated polystyrene (SPS) were formed by compression molding at a temperature at which the thermoplastic matrix was in the melt state. They were thermally analyzed by differential scanning calorimetry. Tensile specimens were cut from the compression-molded plates, and mechanical tests were performed. The morphology of the material systems was studied by performing scanning electron microscopy analysis on cryogenically fractured specimens. For LCP/PS and LCP/SPS systems, a sharp two-phase morphology was formed, which suggested poor interfacial adhesion. The tensile strength of both systems decreased with LCP addition. The LCP/PC system also revealed a two-phase morphology; however, the interfaces between the LCP domains and the PC matrix were not so well defined, showing better interfacial adhesion than the two previous systems studied. Stronger bonding between the LCP and PC resulted in a significant improvement in the mechanical behavior of PC by LCP addition. © 1997 John Wiley & Sons, Inc. J Appl Polym Sci 64: 645–652, 1997
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
