Abstract
The danger of buckling and instability structures easily occurs on the steel beam structure, it will make the structure fails before it reaches the cross section ultimate capacity.In that case the strength of a beam is not only determined by cross-section ultimate capacity. The instability of the structure causes lateral torsional buckling eventhough there is no torque on the beam. There is one way to support the stability of the beam; by installing lateral support on its side. This research is intended to obtain information about flexural strength by comparing the theoretical results based on SNI 03-1729-2002 and (Indonesian National Standard Draft) RSNI 03-1729.1- 201x with the results of experimental testing and finite element analysis results (using the ABAQUS program). The flexural specimens which are studied are in the long-span with a length of 3.3 meters span test. The loading uses three-point load system. The results of the test show information that flexural strength for the long-span specimen from experimental test results has the smallest difference of 33.18% of the theoretical result. As for analysis with FEM also hasthe same difference of 33.18% with the experimental results. Failure that occurs for long-span specimen is due to lateral torsional buckling failures.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.