STRUCTURE, OPTICAL PROPERTIES AND PHOTOCATALYTIC ACTIVIYY OF UNDOPED, La2O3-DOPED ZnO NANOCOMPOSITES

Abstract

La-doped ZnO nanocomposites with di­ffe­rent content of La2O3 (1–5%) were obtained by the Pechini method from their nitrate solutions. The solutions of Zn2+ and La3+ nitrates were preliminary obtained by dissolving of zinc and lanthanum oxides with a content of the main component of 99.99% in nitric acid. The influence of lanthanum doping the on the microstructure, morphology, optical pro­perties and photocatalytic activity of the ZnO nanopowders were examined. The properties of the nanopowders were studied by using X-ray phase analysis, scanning electron microscopy (SEM), energy dispersive X-ray spectroscopy. The samples were subjected to X-ray powder diffraction using a DRON-3 diffractometer (Cu-K radiation) at room temperature. The scan angle was 0.05–0.1 ° in the range 2 = 15–90 °. X-ray phase ana­lysis confirms the formation of single phase of La2O3-doped ZnO powders on diffractograms. Raman light scattering and photoluminescence spectra were recorded using a Horiba Jobin‑Yvon T64000 spectrometer equipped with a CCD detector at room temperature in the inverse scattering geometry. According to SEM results, the powders characterized a conglomerate structure. The undoped ZnO has an average particle size of 43 nm, while the average particle size of La3+-doped ZnO ranges from 64 to 80 nm. It was established that the morphology of powder particles primarily depends on the content of La3+ in the material. An increase in the amount of La3+ in zinc oxide leads to an increase in the specific surface area (from 3.8 to 11.8 m2/g). In the photoluminescence spectra of ZnO powders, with increasing La2O3 concentration, bands at 400 nm are observed due to the appearance of impurities that cause of interstitial zinc and zinc vacancy defects and their broade­ning with a shift to the long-wave region. Photocatalytic properties of ZnO pow­ders doped with lanthanum oxide were in­vestigated using Methyl Orange as a model dye under Osram Ultra-Vitalux lamp (300 W) irradiation. A present result indicates that the obtained powders are potential candidate for the practical application in photocatalysis.