Abstract
AbstractDrying oils have been considered as water resistant coatings for bio‐based packaging materials; however, their curing rates are slow for industrial applications. Infrared radiation was investigated in this study as a means to increase the curing rate of linseed and tung oils. The effect of oil pretreatment with gamma radiation was also investigated. FTIR spectroscopy was used to monitor chemical changes during oil oxidation. Results indicated that infrared radiation increased the curing rate of linseed and tung oils. The oxidation rate of both oils, as monitored by the decrease of the 3010 cm−1 FTIR peak, followed an exponential decay. The structure of cured films was examined by SEM. Images of films cross section were used to develop a qualitative model of the curing process. Linseed and tung oil showed differences in structural development during drying. In the case of linseed oil, the formation of a tough skin layer slowed down oxygen diffusion to the oil underneath, resulting in slow curing. For the case of tung oil, the skin layer shrank as it formed allowing oxygen diffusion and fast curing of tung oil. © 2009 Wiley Periodicals, Inc. J Appl Polym Sci, 2010
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.