Structurally stitched NCF CFRP laminates. Part 1: Experimental characterization of in-plane and out-of-plane properties

Abstract

The insertion of local through-thickness reinforcements into dry fiber preforms by stitching provides a possibility to improve the mechanical performance of polymer–matrix composites perpendicular to the laminate plane (out-of-plane). Three-dimensional stress states can be sustained by stitching yarns, leading to increased out-of-plane properties, such as impact resistance and damage tolerance. On the other hand, 3D reinforcements induce dislocations of the in-plane fibers causing fiber waviness and the formation of resin pockets in the stitch vicinity after resin infusion which may reduce the in-plane stiffness and strength properties of the laminate. In the present paper an experimental study on the influence of varying stitching parameters on in-plane and out-of-plane properties of non-crimp fabric (NCF) carbon fiber/epoxy laminates is presented, namely, shear modulus and strength as well as compression after impact (CAI) strength and mode I energy release rate. The direction of stitching, thread diameter, spacing and pitch length as well as the direction of loading (which is to be interpreted as the direction of the three rail shear loading or the direction of crack propagation in case of mode 1 energy release rate testing) were varied, and their effect on the mechanical properties was evaluated statistically. The stitching parameters were found to have ambivalent effect on the mechanical properties. Larger thread diameters and increased stitch densities result in enhanced CAI strengths and energy release rates but deteriorate the in-plane properties of the laminate. On the other hand, a good compromise between both effects can be found with a proper selection of the stitching configurations.