Structural Formation of Alkali-Activated Materials Based on Thermally Treated Marl and Na2SiO3.

Abstract

Modern materials science is aimed towards abandoning Portland cement in the production of building materials. The scientific novelty of this study lies in its being the first time a comprehensive study of the structure formation of alkali-activated materials (AAM) based on thermally treated marl and Na2SiO3 is carried out. The tasks for achieving this goal were to characterize the thermally treated marl as a new binder, and to comprehensively research the microstructure, fresh, physical, and mechanical properties of the AAM based on the binder. Received active particles of marl with a smaller size than Portland cement have a specific surface area of 580–590 m2/kg. The mineral composition of heat-treated marl is characterized by calcium silicates, which guarantee good binding properties. The results of X-ray diffraction analysis of the samples based on the clinker-free binder of alkaline activation using opoka-like marl confirmed the presence of calcite, quartz, and feldspar close to albite, micas, and zeolites. The obtained products of the chemical interaction of the components of the binder confirm the effectiveness of the newly developed AAM. As a result of comparing several binders, it was found that the binder “thermally treated marl—Na2SiO3” is the most effective, since for specimens based on it, a maximum compressive strength of 42.6 MPa, a flexural strength of 4.6 MPa, and minimum setting time were obtained (start 26 min, end 32 min) as well as a water absorption of 10.2 wt.%. The research results will be of interest to specialists in the construction industry, since the proposed recipes for clinker-free cements are an alternative to expensive and energy-intensive Portland cement and provide the creation of strong and durable concrete and reinforced concrete composites.