Structural, electric and pyroelectric properties of up and down graded PZT multilayers

Abstract

Multi-layered structures, composed of thin films from materials with different compositions or physical properties, represents a way to obtain enhanced properties or even new functionalities. In this work, lead zirconate titanate PbZrxTi1-xO3 (PZT; x = 0.20, 0.52, 0.80) multilayers were grown by pulsed laser deposition (PLD) on a single crystal strontium titanate (SrTiO3, STO) substrate, using a strontium ruthenate (SrRuO3, SRO) film as buffer layer for epitaxial growth, and also as back electrode.Up and down multi-layers were grown and their physical and structural properties were compared, up being the structure in which Zr concentration was varied from 20% near the STO substrate to 80% at the surface, while down is for the structure in which the Zr concentration starts with 80% near the substrate and ends with 20% at the surface. It was found that the electric and pyroelectric properties of the two graded structures are significantly different. The up structure presents electric properties that are comparable with those of single composition PZT films while the properties of the down structure are deteriorated, especially in terms of the leakage current magnitude. Pyroelectric signal could be measured only for the up structure. These differences were attributed to larger density of structural defects in the down structure compared to the up one. This is due to the different growth sequence: up structure starts with tetragonal PZT on cubic substrate (lower lattice mismatch, 1.1%) while down structure starts with rhombohedral PZT on cubic substrate (larger lattice mismatch, almost 5%).