Abstract
One‐dimensional nanostructures of niobium‐doped anatase TiO2 (Nb:TiO2) up to 5 at.% Nb were synthesized by electrospinning a polymeric solution containing titanium and niobium precursors and subsequent annealing. Thus obtained fibers had diameter ∼150 nm. The undoped TiO2 fibers were constituted by larger single crystalline grains of size ∼50 nm, whereas the doped ones had decreased grain sizes (∼30 nm) under similar processing conditions. The Nb doping decreased the BET surface area of TiO2. A strain‐induced lattice contraction was observed in Nb:TiO2. The continuous nanofibers were shortened to nanowires (NW) of aspect ratio 10:1 by ultrasonically dispersing them in acetic acid, which were developed as films of thickness ∼8–13 μm onto conducting glass substrates. The TiO2 and Nb:TiO2 nanowire films were further sensitized by a dye; the amount of dye anchored was found to decrease with increase in the dopant concentration. The dye‐sensitized solar cells fabricated using the doped fibers, although with a nominally increased current density (JSC), have reduced efficiency due to lower fill factor and open circuit voltage (VOC). The electron diffusion coefficient (Dn) and mobility (μn) of the TiO2 and Nb:TiO2 NW in the presence of iodide/triiodide ions were an order of magnitude higher compared with the undoped samples.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
