Abstract
Nineteen out of 26 bolts (studs) used for assembly of multistage water pump showed severe corrosion and cracking after brief service in a severe working environment that contained saline water, CO2, and H2S. The failed bolts and intact nuts were supposed to be made out of a special type of austenitic stainless steel as per ASTM A 193 B8S and ASTM A 194, respectively. However, the investigation showed that bolts and nuts are made from two different alloys: an austenitic stainless steel and a nickel-base alloy. The difference in the corrosion resistance of these two alloys led to severe galvanic corrosion. The galvanic coupling between bolts and nuts in addition to the severe working environment played major role in the premature failure of bolts. The mechanisms of bolt failure were galvanic corrosion for bolts that were in direct contact with the environment and stress-corrosion cracking in the bolts remote from the severe environment. The stress-corrosion cracking was influenced by a bad fit between the bolts and nuts threads. This resulted in a crevice and the development of an aggressive chemistry between the engaged bolt/nut threads. All factors required to cause stress-corrosion cracking were available, namely, stressed bolts (bolts under tensile stress), temperatures above 60 °C, and chloride ions.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call