Stress response of patellofemoral joint subjected to femoral retroversion with various patellar kinematics and flexions – An FEA study

Abstract

The purpose of this study is to observe the stress response of the patellofemoral joint associated with three patellar kinematics: shift, spin and tilt under femoral retroversion conditions. By assigning various flexions and different loads, the stresses were quantified in the bones, tendons, cartilages and cartilage–bone interface. Four different loads of 600, 657, 706 and 753N were applied on 12 models representing each of the various kinematics of shifts, spins and tilts of the patella with femoral flexions of 30°, 60°, 90° and 120° which gave results for 48 analyses. The ‘Q’ angle of the femur bone was maintained at 14° with femoral retroversion of 21°. Based on the patellar kinematics, three different cases were modeled as (a) 5mm shift 10° spin 4° tilt, (b) 10mm shift 13° spin 8° tilt, and (c) 15mm shift 16° spin 12° tilt. Medial shift, spin and tilt with femoral retroversion were limited in this study. The femoral displacement for 30° flexion at 600N was found to be same in all the (a), (b), and (c) cases. Similarly, respective same displacements were achieved in all three cases when subjected to 60° flex at 657N, 90° flex at 706N and 120° flex at 753N. From the simulated results it is inferred that femoral retroversion with case (b) kinematics susceptibly dominated by the cartilages causes patellofemoral joint pain, arthritis and instability due to the larger contact areas between the patella and femur bone at flexions 60° and 90°.