Abstract
Strained pseudomorphic Si/Si <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">1-x</sub> Ge <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">x</sub> /Si gate-controlled band-to-band tunneling (BTBT) devices have been analyzed with varying Ge composition up to 57% and p+ tunnel-junction (source) doping concentration in the 10 <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">19</sup> -10 <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">20</sup> cm <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">-3</sup> range. Measurements show the impact of these parameters on the transfer and output characteristics. Measurements are compared to simulations using a nonlocal BTBT model to analyze the mechanisms of device operation and to understand the impact of these parameters on the device switching behavior. The measured characteristics are consistent with simulation analysis that shows a reduction in energy barrier for tunneling (E <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">geff</sub> ) and a reduction in tunneling distance with increasing Ge composition and source doping concentration. Increases in the pseudomorphic layer Ge content and doping concentration of the tunnel junction produce large improvements in the measured switching-behavior characteristics (I <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">on</sub> , slope, turn-on voltages, and sharpness of turn-on as a function of V <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">ds</sub> ). Simulations are also performed to project the potential performance of more optimized structures that may be suitable for extremely low power applications (V <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">dd</sub> < 0.4 V).
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.