Abstract
The subject of the article is to compare and evaluate the stiffness of the proposed structures relative to the section of the individual rods. The study is applicable to the additive technology of metal production by the 316L (1.4404) by SLM method. In the SLM process the design supports serves as the transporter of the heat generated in the melting bath to the substrate, the secondary function of the structures is for support the powder layer. The article focuses on the supportive function and weight ratio. A total of 4 structures were designed in iteration with three different rod diameters. During construction, the suitability of structures for the SLM method was determined and then the samples were subjected to a mechanical tensile test and the mechanical properties evaluated. In conclusion the most appropriate structure for the supportive function was identified.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.