Stick‐Slip Nucleation and Failure in Uniform Glass Beads Detected by Acoustic Emissions in Ring‐Shear Experiments: Implications for Identifying the Acoustic Emissions of Earthquake Foreshocks

Abstract

AbstractStress accumulation and release reflected by acoustic emissions (AEs) during shearing of granular materials provide important information on failure mechanisms in seismic faults and landslides controlled by stick‐slip. Among many characteristics (amplitude, energy, counts, and frequency) of AE signals generated by stick‐slip, stress changes corresponding to various frequency AEs in different stages of the stick‐slip process are not clear, which limits our knowledge of the characteristics of precursory signals before stick‐slip failure. To better understand the physical mechanisms of granular stick‐slip, we monitored the mechanical and AE signals using high‐frequency (2 MHz) synchronous acquisition during constant‐speed shear of packs of uniform glass beads with different sizes at different normal stresses. The release rate of AE energy was found to accelerate with the dilatation of the sample volume, and the stress drop of stick‐slip was augmented with the increase of normal stress and particle size. Three characteristic events of single cycle stick‐slip were observed in this study: main slip, minor slip, and microslip. We analyzed the AE frequency spectra of these three event types. Both main slip and minor slip corresponded to stress drop and generated high‐frequency AEs (about several hundred kHz), while the AE frequencies generated by microslip were lower (about tens of kHz) and exhibited stress strengthening, which were not apparent in previous studies due to the low frequency of acquisition. We propose that the microslip is mainly due to sliding on grain contacts, while the main slip and minor slip resulted from breakage and reforming of force chains. Low‐frequency AEs from microslip may suggest a crucial precursor of seismic faults and landslides.