Abstract
The wind power plant has an important component, namely a generator which is an electrical engine that converts mechanical energy into electrical energy. This paper discusses the design of the permanent rotor axial flux generator (Single Rotor Single Stator) using a slotted stator and using a slotted stator reference design. To find out more in detail, this work was conducted by comparing four different generator designs, the number of slots and tooth widths. Testing the width of the teeth and the number of slots varied, including 12 slots width of teeth 23 mm, 15 slots width of teeth 18 mm, and 18 slots width of teeth 15 mm. The permanent magnet used in this study is neodymium iron boron, NdFeB 48/11 with a total of 10 poles. The desired reference power is 100 Watt with a speed of 500 Rpm. The outputs of each design in the form of voltage, current, power, and efficiency are discussed. The conclusion obtained that the additional teeth to the stator and increasing the number of axial flux slots affect the specified output parameters. The result of using teeth is that the voltage, current, and power are getting bigger and the more number of slots the smaller the voltage, current, and power.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IOP Conference Series: Materials Science and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
