Statistical variability and fragility assessment of ballistic perforation of steel plates for 7.62 mm AP ammunition

Abstract

The paper describes field test results of 7.62 × 51 mm M61 AP (armour piercing) ammunition fired into mild steel targets at an outdoor range. The targets varied from 10 mm to 32 mm in thickness. The tests recorded penetration depth, probability of perforation (i.e., complete penetration), muzzle and impact velocities, bullet mass, and plate yield strength and hardness. The measured penetration depth exhibited a variability of approximately ±12%. The paper then compared ballistic test results with predictive models of steel penetration depth and thickness to prevent perforation. Statistical parameters were derived for muzzle and impact velocity, bullet mass, plate thickness, plate hardness, and model error. A Monte-Carlo probabilistic analysis was then developed to estimate the probability of plate perforation of 7.62 mm M61 AP ammunition for a range of impact velocities, and for mild steels, and High Hardness Armour (HHA) plates. This perforation fragility analysis considered the random variability of impact velocity, bullet mass, plate thickness, plate hardness, and model error. Such a probabilistic analysis allows for reliability-based design, where, for example, the plate thickness with 95% reliability (i.e. only 1 in 20 shots will penetrate the wall) can be estimated knowing the probabilistic distribution of perforation. Hence, it was found that the plate thickness to ensure a low 5% probability of perforation needs to be 11–15% thicker than required to have a 50/50 chance of perforation for mild steel plates. Plates would need to be 20–30% thicker if probability of perforation is reduced to zero.