Abstract

BackgroundCurrent commercial prosthetic hand controllers limit patients’ ability to fully engage high Degree-of-Freedom (DoF) prosthetic hands. Available feedforward controllers rely on large training data sets for controller setup and a need for recalibration upon prosthesis donning. Recently, an intuitive, proportional, simultaneous, regression-based 3-DoF controller remained stable for several months without retraining by combining chronically implanted electromyography (ciEMG) electrodes with a K-Nearest-Neighbor (KNN) mapping technique. The training dataset requirements for simultaneous KNN controllers increase exponentially with DoF, limiting the realistic development of KNN controllers in more than three DoF. We hypothesize that a controller combining linear interpolation, the muscle synergy framework, and a sufficient number of ciEMG channels (at least two per DoF), can allow stable, high-DoF control.MethodsTwo trans-radial amputee subjects, S6 and S8, were implanted with percutaneously interfaced bipolar intramuscular electrodes. At the time of the study, S6 and S8 had 6 and 8 bipolar EMG electrodes, respectively. A Virtual Reality (VR) system guided users through single and paired training movements in one 3-DoF and four different 4-DoF cases. A linear model of user activity was built by partitioning EMG feature space into regions bounded by vectors of steady state movement EMG patterns. The controller evaluated online EMG signals by linearly interpolating the movement class labels for surrounding trained EMG movements. This yields a simultaneous, continuous, intuitive, and proportional controller. Controllers were evaluated in 3-DoF and 4-DoF through a target-matching task in which subjects controlled a virtual hand to match 80 targets spanning the available movement space. Match Percentage, Time-To-Target, and Path Efficiency were evaluated over a 10-month period based on subject availability.Results and conclusionsIn 3-DoF, S6 and S8 matched most targets and demonstrated stable control after 8 and 10 months, respectively. In 4-DoF, both subjects initially found two of four 4-DoF controllers usable, matching most targets. S8 4-DoF controllers were stable, and showed improving trends over 7–9 months without retraining or at-home practice. S6 4-DoF controllers were unstable after 7 months without retraining. These results indicate that the performance of the controller proposed in this study may remain stable, or even improve, provided initial viability and a sufficient number of EMG channels. Overall, this study demonstrates a controller capable of stable, simultaneous, proportional, intuitive, and continuous control in 3-DoF for up to ten months and in 4-DoF for up to nine months without retraining or at-home use with minimal training times.

Highlights

  • Current commercial prosthetic hand controllers limit patients’ ability to fully engage high Degree-ofFreedom (DoF) prosthetic hands

  • Controllers which provided unreliable control over single-Degrees of Freedom (DoF) movements were typically declared ‘unusable’. Both subjects found the 3-DoF (3D) controller and two of four 4-DoF controllers usable—one with the thumb controlled by a thumb movement (TH) and one with the thumb controlled by a radial-ulnar movement of the wrist (RU). (Table 2)

  • 3‐DoF performance over time 3-DoF controllers were evaluated for both subjects shortly after training and again after a period of 8–10 months (Fig. 3)

Read more

Summary

Introduction

Current commercial prosthetic hand controllers limit patients’ ability to fully engage high Degree-ofFreedom (DoF) prosthetic hands. Current commercially available myoelectric hand prostheses are typically limited to one or two Degrees of Freedom (DoF) and experience a 10–35% abandonment rate [1]. The man–machine interface, limited in both feed-forward control and closed-loop control, is a major contributor to abandonment [2, 3]. Advanced prosthetic systems, such as the 10-DoF DEKA/ LUKE Arm [4] and the 16-DoF Modular Prosthetic Limb [5], have expanded prosthetic hand capabilities, but place even higher demands on prosthetic hand controllers. Using ciEMG to improve feed-forward EMG controllers could allow users to gain more functional benefit from both advanced and commercially available prosthetic devices

Methods
Results
Discussion
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call