Stability and failure rate during 3 years of fixed retention: A follow-up of an randomized clinical trial on adolescents with four different lingual retainers.

Abstract

To evaluate stability outcomes and failure rates associated with four types of lingual retainers: (1) dead-soft wire, (2) multistrand stainless steel (SS) wire, (3) CAD/CAM nitinol, and (4) connected bonding pads (CBPs) after 3 years of retention. This study enrolled 96 patients (66 females, 30 males) with a median age of 19 years with four types of lingual retainers: (1) 0.016 × 0.022-inch dead-soft wire, (2) 0.0215-inch five-strand SS wire, (3) 0.014 × 0.014-inch CAD/CAM nitinol wire, and (4) CBPs. The irregularity index, intercanine distances, and arch lengths were obtained and used to evaluate mandibular stability. Failure rates were also assessed during this study. Data were statistically analysed. Irregularity increased, whereas intercanine width and arch length decreased after 3 years of retention. The greatest irregularity was associated with the CBPs and the least with the CAD/CAM retainers. Changes in stability measurements were significantly higher in the dead-soft wire and CBPs than those in the CAD/CAM nitinol and multistrand SS wires. Parallel to these changes, the frequency of failure yielded similar results with the same significance between the groups. The failure rate of CBPs, in contrast to the CAD/CAM nitinol and multistrand SS wires, was significantly higher in the right quadrant (P < .05). After taking the 3-year results into consideration, CAD/CAM nitinol and multistrand SS wires were found to be more successful than the others in maintaining mandibular stability. The most failures were observed with CBPs after 3 years of retention.