Abstract
This paper describes results on an experimental study of faint light emission produced by separation of an adhesive tape from a glass or from a polymer film. Spectroscopic measurements of the faint light were carried out using a monochromator and a photomultiplier. The results indicated that the light emission was caused by discharges near the tape-air-glass triple junction. We found that the frequency of the light emission was strongly changed by changing the peeling speed of the tape. Discharge lights were detected in many times in the case of high-speed peeling, whereas no light was detected in the case of low-speed peeling. We also measured surface potential distributions on the film after separation from the tape using a XY-movable probe and an electrostatic voltmeter. The surface potential on the film after the fast-speed peeling became slightly higher than that on the film after the low-speed peeling.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
