Sonar Metering Optimizes Production in Liquid-Loading-Prone Gas Wells

Abstract

This article, written by JPT Technology Editor Chris Carpenter, contains highlights of paper SPE 166652, ’Use of Sonar Metering To Optimize Production in Liquid-Loading-Prone Gas Wells,’ by C.A. Shields and M. Dollard, Marathon Oil UK, and S. Sridhar, G. Dragnea, and M. Illingsworth, Expro Meters, prepared for the 2013 SPE Offshore Europe Oil and Gas Conference and Exhibition, Aberdeen, 3-6 September. The paper has not been peer reviewed. This paper discusses the use of clamp-on sonar flowmeters to minimize losses associated with well testing and to gain the subsequent benefits seen with respect to production optimization and well deliquefication. Clamp-on sonar flowmetering is a nonintrusive technology that measures the flow velocity of the fluid stream. This intensive well-management strategy has assisted in reducing the production decline of the East Brae field in the North Sea. Introduction The East Brae platform (Fig. 1) is located 275 km northeast of Aberdeen in Block 16/3a in a water depth of 110 m. The reservoir comprises high- permeability sands deposited by turbidity currents. The reservoir has an average porosity of 17% and an average permeability of 558. md. The platform initially started producing condensate, while reinjecting the gas, in December 1993. Exporting of the gas began in 1994, and reinjection was phased out. The current topside holds a low- pressure (LP) separator (test separator) operated at 217 psig, a high-pressure (HP) separator (first-stage separator) currently operated at 406 psig, and second- and third-stage separators. It also includes a gas-processing and - dehydration plant, three gas-compression trains, and produced-water-processing facilities for discharge into the sea. There are currently 12 producing monobore wells on the East Brae platform. Former gas-injection wells have now been converted to producing wells. The wells are inclined up to a maximum deviation of 45°. The reservoir fluid is a retrograde gas condensate that exhibits compositional variation with depth. The reservoir has an active aquifer that has encroached into the producing layers as reservoir pressure has depleted through production. Background: Allocation and Well Testing On the East Brae platform, production allocation for the wells has typically been carried out by individual well tests of each well in the test separator on a monthly basis. The well test records the amount of oil and gas produced from a well during the first stage of separation. The oil and gas are then processed further in the plant. Some of the oil is vaporized into the gas phase as it is stabilized in lower-pressure separators, and some of the gas is liquefied as it is cooled and compressed. As a result of these equilibrium changes, the oil and gas rates exported from the platform (known as its “potentials”) that are attributable to a single well are not directly comparable with the oil and gas rates measured at the test separator for that well.