Solid dispersion particles of amorphous indomethacin with fine porous silica particles by using spray-drying method

Abstract

The solid dispersion particles of indomethacin (IMC) were prepared with different types of silica, non-porous (Aerosil 200) or porous silica (Sylysia 350) by using spray-drying method. Powder X-ray diffraction analysis showed that IMC in solid dispersion particles is in amorphous state irrespective of the type of silica formulated. In DSC analysis, the melting peak of IMC in solid dispersion particles with Sylysia 350 shifted to lower temperature than that in solid dispersion particles with Aerosil 200 although the peak of each solid dispersion particles was much smaller than that of original IMC crystals. Dissolution property of IMC was remarkably improved by formulating the silica particles to the solid dispersion particles. In comparing the effect of the type of the silica particles, the dissolution rate of solid dispersion particles with Sylysia 350 was faster than that with Aerosil 200. The formulation amount of IMC did not affect on the amorphous state of IMC in the resultant solid dispersion particles in powder X-ray diffraction patterns. However, the area of the melting peak of IMC in the solid dispersion particles increased and an exothermic peak owing to recrystallization was observed with increasing the IMC content in the DSC patterns. The dissolution rate of IMC from the solid dispersion particles with Sylysia 350 was faster than that of Aerosil 200 irrespective of IMC content. In stability test, amorphous IMC in the solid dispersion particles with each silica particles did not crystallize under storing at severe storage conditions (40 °C, 75% RH) for 2 months, while amorphous IMC without silica easily crystallized under same conditions.